Installation & Assembly

Top-Mount / Under-Mount Sinks
INSTALLATION GUIDE
Page 4 of 4
Care and Cleaning
Cleaning
 Clean regularly with a mild detergent solution and/or clean water applied with a soft cloth or
sponge. Rub gently.
 Rinse and wipe the sink dry after every use to prevent water spotting &mineral deposits in
severe hard water conditions.
 Deep clean once a week with a recommended cleanser (be sure to rub in the direction of the
finish lines) and a soft cloth or sponge rather than aggressively cleaning.
Please note chlorides are found in most all soap, detergents, blenches and cleansers. Chlorides can
be harsh on stainless steel. Rinse your sink thoroughly after each use to remove any chloride
residue.
Scratches
Scratches are inevitable during your usage over time. To treat, use a nylon pad with an iron free
abrasive polishing compound. Follow the original polish lines to blend out the scratch in a small
area. Be cautions not to overdo the process, as cleaning too aggressively could result in a bright
spot.
Some Don'ts:
 Do not use any abrasive cleaners such as steel wool or scrub pads.
 Don't leave wet sponges, cloths, cleaning pad, rubber mats or dishpans in the sink. This could
lead to surface rust or possible pitting.
 Do not leave standing solutions of chlorine bleach and water in the sink for extended periods of
time. Always rinse the sink after using such solutions.
 Do not allow liquid soap or other cleansers to dry on the surface of the sink.