User's Manual

4080SC4071, SCO71-H
Polar pattern
SC4060/61/62/63, SCO60-H/61-H
DPZ-4060-3
US Sales Ofce
DPA Microphones, Inc.
1500 Kansas Avenue, Unit 3A
Longmont, CO 80501
Tel: +1 303-485-1025
Fax: +1 303-485-6470
info-usa@dpamicrophones.com
www.dpamicrophones.com
APAC Sales Oce
DPA Microphones Ltd.
Unit 801-2, 8/F, Asia Orient Tower
33 Lockhart Road, Wanchai
Hong Kong
Tel: +852 2617 9990
Fax: +852 2617 9887
www.dpamicrophones.com
info-apac@dpamicrophones.com
Head Ofce
DPA Microphones A/S
Gydevang 42-44
DK-3450 Alleroed, Denmark
Tel: +45 4814 2828
Fax: +45 4814 2700
info@dpamicrophones.com
www.dpamicrophones.com
This product is produced by www.spreadcard.com , # 11007
Directional characteristics
SC4060/61/62/63/71, SCO60-H/61-H/71-H: Omnidirectional
4080: Cardioid
Principle of operation
SC4060/61/62/63/71, SCO60-H/61-H/71-H: Pressure
4080: Pressure Gradient
Cartridge type
Pre-polarized condenser element with vertical diaphragm
Frequency range, ± 2 dB
SC4060/61/62/63, SCO60-H/61-H:
Soft boost grid: 20 Hz- 20 kHz, 3 dB soft boost at 8 – 20 kHz
High boost grid: 20 Hz- 20 kHz, 10 dB boost at 12 kHz
SC4071, SCO71-H:
100 Hz – 15 kHz with typ. 5 dB soft boost at 4-6 kHz
4080:
250 Hz – 17 kHz with typ. 4 dB soft boost at 4 - 6 kHz (-5 dB at 100 Hz)
Sensitivity, nominal, ± 3 dB at 1 kHz
SC4060, SCO60-H, 4080: 20 mV/Pa; -34 dB re. 1 V/Pa
SC4061/63/71, SCO61-H/71-H: 6 mV/Pa; -44.5 dB re. 1V/Pa
SC4062: 1 mV/Pa; -60 dB re. 1V/Pa
Equivalent noise level, A-weighted
SC4060, SCO60-H, 4080: Typ. 23 dB(A) re. 20 µPa (max. 26 dB(A))
SC4061/63/71, SCO61-H/71-H: Typ. 26 dB(A) re. 20 µPa (max. 28
dB(A))
SC4062: Typ. 33 dB(A) re. 20 µPa (max. 37 dB(A))
S/N ratio (A-weighted) re. 1 kHz at 1 Pa (94 dB SPL)
SC4060, SCO60-H, 4080: 71 dB
SC4061/63/71, SCO61-H/71-H: 68 dB
SC4062: 61 dB
Total Harmonic Distortion (THD)
<1% THD up to 123 dB SPL peak
<1% THD up to 120 dB SPL RMS sine
Dynamic Range
SC4060, SCO60-H, 4080: Typ. 100 dB
SC4061/63/71, SCO61-H/71-H: Typ. 97 dB
SC4062: Typ. 90 dB
Max. SPL peak before clipping
SC4060, SCO60-H, 4080: 134 dB
SC4061/71, SCO61-H/71-H: 144 dB
SC4062: 154 dB
SC4063: 138 dB
Output impedance
30 – 40 Ω, depending on current draw
Cable drive capability
300 m (984 ft) with DAD6001-BC/DAD6024/DAD4099 XLR phantom
power adapter
Power supply
With DAD6001-BC/DAD6024/DAD4099: 48 V phantom power ±4 V
for full performance.
For wireless systems: Min. 5 V through DPA adapter (SC4063 min. 3 V).
Polarity
Positively increasing sound pressure produces positive going voltage on
MicroDot pin.
Connector
MicroDot, adapters are available
Weight incl. cable and MicroDot connector
SC4060/61/62/63: 7.5 g (0.26 oz)
SC4071: 9 g (0.32 oz)
4080: 15 g (0.53 oz)
SCO60-H/61-H: 13 g (0.46 oz)
SCO71-H: 14 g (0.49 oz)
Cable length
1.8 m (5.9 ft) (4080: 1.2 m (4 ft))
Cable diameter
SC4060/61/62/63/71, 4080: 1,6 mm (0.06 in)
SCO60-H/61-H/71-H: 2,2 mm (0.09 in)
Temperature range
-40 °C to 45 °C
Relative Humidity (RH)
Up to 90%
Specifications
SC4060, SC4061, SC4062, SC4063, SC4071
4080, SCO60-H, SCO61-H, SCO71-H
4080
SC4071, SCO71-H
Frequency Response
SC4060/61/62/63, SCO60-H/61-H
Warranty
All products from DPA Microphones are covered by a
two-year limited warranty on both mechanical func-
tionality and documented specifications as long as the
items are not mistreated, abused or modified in any way.
In case of a warranty claim your invoice is your warranty reg-
istration.
Service & Repair
Products from DPA Microphones are extremely stable and
there should not be any significant change in the specifications
with time and use. If, however, you are not totally satisfied with
the characteristics exhibited by these products, please contact
your nearest DPA Microphones representative for further de-
tails of service and the repair facilities that are available.
CE Marking
The CE mark guarantees that the product conforms with relevant
directives approved by the European Commission.
EMC directive: 2004/108/EEC
Low voltage directive: 2006/95/EC
Environmental Policy
This product is comprised by the Waste (WEEE) directive and
should not be thrown in the garbage bin when obsolete. Instead,
return it to your local DPA representative (or DPA Microphones
A/S directly) who will dispose of the product in accordance with
the current environmental standards.
RoHS directive: 2002/95/EC
WEEE directive: 2002/96/EC
© October 2014, DPA Microphones A/S
Product features and specifications are subject to change without notice.