User's Manual

Adjusting the d:fine
TM
4065
4065 is pre-formed but may require adjustment in order to get a tight, fixed position to the back of
the neck. Adjust the steel tube carefully at the curves.
A protection grid is mounted over the microphone head. If clogged with dirt or make-up,
gently remove it and clean it with distilled water.
Adjusting the d:fine
TM
4066, 4067, and 4088
The size of the headset mount can easily be adjusted. Change the standard bend by carefully expand-
ing the distance between the earhooks.
To change sides, simply click the boom out of the clips and switch it over to the other side.
The remaining two clips are not used. The soft cable must not be attached into the clips.
Adjusting the d:fine
TM
Omnidirectional, d:fine
TM
Directional, d:fine
TM
66 and d:fine
TM
88.
The directional characteristics of the microphone is indicated on the flat microphone
head with for omnidirectional and for directional as shown on page 3. This marking
should always point towards the mouth. Mount a directional headset 2 – 3 cm (1 in) from the
corner of the mouth to ensure optimal sound quality.
For the single-ear, just open the spring hook lightly, first place the slide behind your ear
-
lobe (Pic. 1) and let go of the spring over your ear (Pic. 2). For the dual-ear, place the
headset behind your ears and place the springs like for the single-ear. Adjust the headset
mount by pulling or pushing the wires until it fits tight (Pic. 3).
3. The relief is pre-mounted with dual-ear headsets
and supplied with single-ear.
2. Slide the cable into the relief cut.
Correct placement behind the earlobe
Pic. 1 Pic. 2 Pic. 3
See instruction video at
dpamicrophones.com/dfine
1. When using the dual-ear mount,
the supplied cable relief should be applied.