Installation Guide

F. Pivot the Strongback to 0-degrees (level to the ground) and hold in position.
G. Slide the Support Bar Mounting Tab to align the mounting holes of the
Support Bar with its Pivot Tab on the Mounting Sleeve. Slide the Support
Bar over the Pivot Tab. Insert the 3/8” x 1-1/4” bolt and one flat washer thru
the Support Bar and Mounting Tab and secure it with the remaining flat
washer, lock washer and hex nut.
(See Figure 4-3)
Torque hardware on both ends of
Support Bar at 32-34 ft.-lbs. Torque the 3/8” Flange Nuts at 32-34 ft.-lbs.
7 of 11
Figure 4-2: Loosening the Support Bar Mounting Tab
Strongback
Support Bar
Pivot
Tab
Loosen Four
3/8” Flange Nuts
to Adjust Position
Figure 4-3: Securing Support Bar to Mounting Sleeve
3/8” Boltx 1-1/4”
Flat Washer
Flat Washer
Lock Washer
3/8” Hex Nut
Assembly Instructions, Top-of-Pole Mount for 6 Modules (TPM6) For Module Type A, B, & C (Version 2, Rev D)