User's Manual

3626VisionNet M505N
2.D Specify WAN IP Settings
PPP Authentication Client
Username
Password
Service Name (usually blank)
Authentication Method (usually AUTO)
NAT:
Translation from WAN to LAN IPs
Full Cone NAT:
Augments NAT by keeping translated port
associations open
Firewall:
Necessary for Management Services, Port
Forwarding, etc.
Dial on Demand:
If enabled, PPP will disconnect, after the
specified period of time, until hosts request
internet access
PPP IP Extension
Disables NAT, and forward IP to first DHCP
requesting host from LAN.
Static IP Settings
If Static IPs for v4, or v6, are to be assigned in
lieu of DHCP
IPv6 Settings
IPv6 DHCP / RADVD settings
PPP Debug Mode
Sends all PPP service activity to syslog – for
testing only
Bridge PPPoE Frames between WAN and
Local Ports
Allows PPP Requests to be made from LAN
Hosts
Enable IGMP Multicast:
Only to be used, for IPTV WAN Services,
where IGMP proxy is required. Do not enable
otherwise.
Enable MLD Multi-Cast Proxy
Allows MLD outside of local domain
Once complete, select “Next”
Page of User Manual Rev 0.1e