User's Manual

3634VisionNet M505N
SECTION 5.2 LED Functionality
Label Description Functionality
Power
Status Power / Router Solid Green – Power On
Off – Power Off
Flashing Green 2 hz – Flashing Power on self test
Flashing Red 4 hz- Failure (not bootable) or device malfunction
A malfunction is any error of internal sequence or state that will prevent the device
From connecting to the DSLAM or passing customer data. This may be identified at
various times such after power on or during operation through the use of self testing or in
operations which result in a unit state that is not expected or should not occur.
Ethernet 1
Status Ethernet Port Off - Power Off – or – No Powered device detected
Solid Green – Powered device connected ; including wake on LAN
Flashing Green – LAN activity present for that port
Ethernet 2
Status Ethernet Port Off - Power Off – or – No Powered device detected
Solid Green – Powered device connected ; including wake on LAN
Flashing Green – LAN activity present for that port
Ethernet 3
Status Ethernet Port Off - Power Off – or – No Powered device detected
Solid Green – Powered device connected ; including wake on LAN
Flashing Green – LAN activity present for that port
Ethernet 4
Status Ethernet Port Off - Power Off – or – No Powered device detected
Solid Green – Powered device connected ; including wake on LAN
Flashing Green – LAN activity present for that port
LED Location specifies Link Status 10 / 100 / GbE
Wireless
Status WiFi Off - Modem off or Wireless not activated
Solid Green – Wireless activated
Flashing Green 2 hz– WPS Activated – Association Period
Flashing Green 4 Hz - Wireless Activity
Note: Pressing the WiFi button enables a re-scan of the WiFi Spectrum
WPS
Status WPS Off: WPS Not in use
Solid Green: Devices authenticated via WPS
Flashing Green: WPS authenticated activated, authenticating devices
Note: Presseing the WPS button enables WPS if enabled in the GUI
DSL
Status DSL Link Line 1 Green – DSL Good Sync
Off - Powered off
Flashing Green - DSL Attempting sync
Signal Detection – Flashing 2hz with 50% duty cycle
Carrier Detected, Modem training – Flashing at 4hz with 50% duty cycle
Internet
Status Internet Connection Internet Light – Must indicate at least one type of connection
Solid Green – IP connected – no traffic passing
Device has a WAN IP via either static/ DHCP/ or IPCP
If PPP is used, device has authenticated and has a WAN IP Address
If IP or PPPOE session is idle and dropped, light to remain green as long as ADSL is still
present. Light to turn red if upon attempting new session it fails.
Off – Modem Power Off.
LED Should remain off if modem is in bridged mode or if DSL Connection is not present
Flashing Green – Device has WAN IP Address and IP Traffic is passing through device
Red – Device attempted initiate session, either authentication or to obtain an IP Address, and
failed. an IP Address, and failed.
Page of User Manual Rev 0.1e