INDUSTRIAL FAN FORCED HEATER OWNER’S MANUAL MODEL NO.
TABLE OF CONTENTS Important Instructions………………………………………. 3 Parts of the Heater ……………………….………………… 5 Grounding and Operating Instructions…………………… 5 Specifications ………………………………………………. 6 Cleaning and Maintenance………………..………………. 6 Storage………………………………………………………. 6 Troubleshooting……………………………………………..
IMPORTANT INSTRUCTIONS PLEASE READ ALL INSTRUCTIONS BEFORE USING THIS HEATER NOTE: There may be a trace of smoke or odor when unit is first operated. Do not be alarmed. This indicates that a drop of oil fell on the heating coil during the manufacturing process. It will quickly evaporate and should not recur. Make sure that the room in which the appliance is located is well ventilated during this operation. It is normal for the appliance to emit small cracking sounds when you turn it on for the first time.
16. Ensure the heater is on a stable, secure floor surface to eliminate the potential of tipping it over. 17. Be sure that the plug is fully inserted into appropriate receptacle. Please remember that receptacles also deteriorate due to aging and continuous use: check periodically for signs of overheating or deformations evidenced by the plug. Should this occur, do not use the receptacle if deteriorated. Call your electrician. 18.
PARTS OF THE HEATER 1. 2. 3. 4. 5. 6. Carry handle Housing Safety grille Heating element Thermostat control Plug (NEMA #6-30P) GROUNDING AND OPERATING INSTRUCTIONS IMPORTANT!! THIS HEATER IS FOR USE ON THE FLOOR ONLY. Prior to operating the heater, ensure the electrical receptacle is of the configuration and capacity appropriate for the heater. See receptacle configuration in OPERATING INSTRUCTIONS. This heater is for use on 240 volts. The cord has a plug as show shown n in #6 above.
YOUR HEATER IS EQUIPPED WITH A THERMOSTAT: 1. Turn the unit ON by turning the thermostat dial away from the OFF position. 2. For faster heat-up or to increase the heat output, turn the Thermostat Control knob all the way to the right [HIGH]. The thermostat function controls the temperature output. To decrease the heat output, turn the knob counter-clockwise. 3. Once the room reaches the desired temperature, slowly turn the Thermostat Control knob counter clockwise until you hear a “click.
TROUBLESHOOTING If your heater fails to operate, please follow these procedures before contacting Customer Services: Problem Probable Cause Solution Overheat protection has temporarily deactivated the heater. Room temperature has warmed to the thermostat setting. Unit is not heating Heater is not plugged into a 240V polarized outlet/receptacle. Turn the heater OFF; unplug it and ALLOW IT TO COOL. Inspect and remove any objects on or adjacent to the heater. Wait 30 minutes before plugging unit back in.
