Carbon Infrared Heater Indoor/Outdoor Owner’s Manual Model No.
Warning THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE, We cannot be liable for any damages caused by failure to observe these instructions. IMPORTANT SAFETY INSTRUCTIONS READ CAREFULLY-The infrared heater is designed for safe operation. Nevertheless, installation, maintenance and operation of the heater can be dangerous. Observing the following procedures will reduce the risk of fire, electric shock, injury to persons and keep installation time to a minimum.
safety. Children and vulnerable people should be supervised to ensure they do not play with the appliance. 18. If the supply cord is damaged in any way, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. 19. To prevent overheating of this appliance, keep the air inlets and outlets clean and free of anything that may cause blockage. Check all inlets and outlets from time to time to ensure it is clear of any dirt or dust accumulation.
INSTALLATION Tools Needed: * Pencil *Hammer *Level *Screw Driver *Power Drill and drill bits A mounting bracket is provided with the heater which has been specifically designed to allow this product to be fitted to ceiling or wall before drilling the holders for the ceiling/wall is solid and that there are no hidden water pipes or electric wires. ATTENTION! The appliance must be installed on the solid surfaces like concrete, wood or metal etc.
20. Fasten the brackets securely to the mounting surface and the backside of the heater using the nuts and screws supplied. 21. Fasten the heater securely on the brackets using the nuts and bolts supplied. 22. The brackets can be used to adjust the direction of the heater, adjust the heater angle by loosening the two bolts on the wall mounting bracket, tighten the bolts again when the desired angle is reached. Installation Accessories parts 1. L shaped bracket 2. Plastic anchor 3. Screw M5*25mm 4.
3. Drill holes with a smaller diameter drill bit than the plastic anchors 4. Insert the point end of plastic anchor into the holes, Tap the anchor with a hammer until the anchor is flush 5. Using a screwdriver attach the mounting bracket to the holes which with plastic anchor inside.
6. Fasten the heater on the L shaped bracket by the black screws on the back of heater Ensure mains power is OFF before commencing installation. The supplied mains cable must not contact the top surface of the heater during operation. The mounting height and intensity should reflect the intended use of the heater.
7|P a g e
FUNCTION & OPERATION OPERATING Product Key Function: 1. Turn on the power, the product is standby mode display (- -); 2. Press key function: press the button, then press the heat levels (L1-L2-L3- standby - off) Remote Control Instructions 1. 2. 3. 4. POWER BUTTON: Turn the heater off. UP BUTTON: Increase timer and level. DOWN BUTTON: Decrease timer and level. LEVEL BUTTON: Use to adjust the heat levels(L1-L3).
NOTICE: 1. Replace the old batteries with the same type batteries. Otherwise, your heater may not function well. 2. Pull out the batteries in case of long terms of disuse to prevent leakage which may impair your remote control. 3. Do not allow water or liquid to get into the remote control.
CLEANING Regular and careful cleaning helps your infrared heater operate efficiently for many trouble-free years. To clean your heater, follow steps below: 1. Unplug the power cord for your safety before cleaning your appliance. 2. Make sure the heater is cool before continuing. 3. To keep the heater clean, the outer shell maybe cleaned with a soft, damp cloth. You may use a mild detergent if necessary. After cleaning, dry the unit with a soft cloth. (CAUTION: DO NOT let liquids enter the heater). 4.
Warranty Information Register your product at our website: Or visit DrHeaterUSA.com/register-your-heater Feedback Love it? Help us make the product more for you. Let us know with a customer review. Please visit: https://www.amazon.com/review/review-your-purchases# At Dr. Heater USA, we are committed to bringing top quality alternative & supplemental heating products to our customers. Note: There may be a trace of smoke or odor when the unit is first operated. Do not be alarmed.