Use and Care Manual

16. Always unplug heater when not in use.
17. Always plug heater directly into a wall outlet/receptacle. Never use with an
extension cord or relocatable power tap (outlet/power strip).
18. It is normal for the heater’s plug and cord to feel warm to the touch. A plug
or cord which becomes hot to the touch or becomes distorted in shape may
be a result of a worn electrical outlet. Worn outlets or receptacles should be
replaced prior to further use of the heater. Plugging this heater into a worn
outlet may result in overheating of the power cord or fire.
19. Make sure the plug is fully inserted into an appropriate receptacle. Be
mindful that receptacles also deteriorate due to aging and continuous use.
Check periodically for signs of overheating or deformations of the plug. If
any overheating or deformation occurs, immediately discontinue using the
heater and contact Dr. Infrared Heater Authorized Service Center.
20. CHECK YOUR HEATER CORD AND PLUG CONNECTIONS. Faulty wall
outlet connections or loose plugs can cause the outlets or plug to overheat.
During use, please check frequently to determine if your plug, outlet or
faceplate is HOT! If so, discontinue using the heater and/or have a qualified
electrician to check and replace the faulty outlet(s).
CAUTION: This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the appliance
by a person responsible for their safety.
SAVE THESE INSTRUCTIONS
Humidifier Installation:
1. Open the humidifier packing and
remove the humidifier, as shown in
Figure 1.
2. Take out the water bottle (Max.
500 ml.) from the package and fill
the water bottle with distilled
water. Then tighten the connector
on the water bottle as shown in
Figure 2.
FIG 1
DC PLUG
WATER
SEAL RING
BOTTLE
CONNECTOR
FIG 2
HOOK