Full Product Manual

Ambient temperature is regulated by adjusting the thermostat to a

desired position. Allow the unit to operate and warm up the room.

When the desired temperature is reached, turn the control knob

counterclockwise until the heater turns off. This is your ideal setting.

The heater will start automatically when the room temperature

drops below this set point, and will turn off when the set point is

reached.

 To turn off the heater, switch off the circuit breaker. The

circuit breaker serves as the only means of disconnecting

power from the heater.

 This heater includes a visual alarm to warn that parts of the

heater are becoming excessively hot. If the alarm flashes,

immediately turn the heater OFF and inspect for any objects on,

in, or adjacent to the heater that may cause high temperatures.

DO NOT OPERATE THE HEATER WITH THE ALARM

FLASHING. To reset the heater, switch the circuit breaker OFF,

and wait five to ten minutes for the unit to cool down before

turning the heater on again.

 How to install Wall Thermostat. (DR-001 Not Included.)

1. Install the Thermostat Outlet Box to the wall. Open the knock-

out on the right.

2. Run line voltage wires to the thermostat location via the

knock-out. Connect the wires as below image: