User Manual

will sample the room temperature less frequently, 30 minutes per sample.
Press and hold the Mode and then press button to cancel the night
mode. Display will show set temperature again
9. Display the room temperature
The display shows the set temperature all the time, press and hold the
MODE button and then press the button. The room temperature will
display for 30 seconds. It will return to set temperature after 30 seconds.
Remote Controller
HOW TO INSERT BATTERIES
NOTE: Remove the batteries if the remote control is not to be used for a month
or more. Batteries left in the unit may leak and cause damage.
DO NOT MIX OLD AND NEW BATTERIES! DO NOT MIX ALKALINE,
STANDARD (CARBON-ZINC) OR RECHARGEABLE (NICKEL-CADMIUM)
BATTERIES!
Instructions for the Use of the IR Remote Control
The buttons on the remote controller functions in the same manner as those on
the control panel on the front of the heater. Set the timer by using the remote
control.
Setting the Timer
1. Press the TIMER button until Set Time starts flashing. The default value is 3
hours.
2. Press the “+” button to increase the
set time or the “–” button to decrease the set time.
The timer can be set from
1 to 12 hours. The timer will set and execute after the LED display stops
flashing. The heater will shut OFF automatically when the set time is
reached.
3. To turn the timer OFF, follow step 1,
pressing the “–” button to set the
time to 0. The timer feature will turn off when the LED stops flashing.
Maintenance
1. Always turn OFF the heater and disconnect the cord from the electrical
outlet before cleaning the unit.