Operation Manual

11
Fig. 27
Fig. 28
Modification to coin box operation
For this procedure 2 persons are needed.
l If the coinbox is not connected yet, separate the
appliance completely from power supply.
l During one person keeps pushing simultaneously the
up and down button at the timer, the other person is
connecting the appliance to power supply again.
l If the coinbox is already connected, the appliance
must not be separated from the power supply.
In this case follow the instructions below:
- one person keeps pushing simultaneously the up
and down button at the timer.
- the other person starts running the coin box by
throwing in a coin
l Keep pushing the up and down button as long as 0
appears on the timer display (fig. 27).
The appliance is now coin box operated.
After release by the coin box the timer is going from 0
minutes upwards.
The appliance can be started and stopped.
The up and down buttons are locked. The other buttons
keep their function.
Resetting to timer operation
The resetting is only possible, if the coinbox is separated
and the wire jumper L1-Time is mounted (see
connection diagram on fig. 26).
For this procedure 2 persons are needed.
l Separate the appliance completely from power supply.
l During one person keeps pushing simultaneously the
face tanner and body fan button at the timer, the other
person is connecting the appliance to power supply
again.
l Keep pushing the face tanner and body fan button
as long as 88 appears on the timer display (fig. 28).
l Afterwards the display expires.
The appliance is now timer operated.
When the time is over, the appliance is completely
switched off and the timer display expires.
Attention: The fan delay has to be executed by the coin
box!
Fig. 29
Freeze the appointed time
l Tune the favoured tanning time at the timer.
l Push the button "fan" and " upward" at the same time
(fig. 29).
Now the sunbed is working as long as the appointed
time is expired.
In between it is not possible to shift the time, the bottons
are blocked. But the sunbed can be switched off an on.
By switching on again the balance time elapses. After
run of time the sunbed cuts off and a new time can be set.
Timer adjustment
jumper 2
jumper 1
jumper 1 (time period):
opened = maximum period 30 min
closed = maximum period 60 min
jumper 2 (fan delay)
opened = without fan delay
closed = with fan delay