Instructions / Assembly

DR Prop Instructions for use: website: www.dr-prop.com
1. Draw a rectangle around the hole in the wall.
2. Cut along the rectangle with a box cutter or knife, and then remove the broken
pieces to achieve a uniform rectangular hole.
3. Trace the hole with a pencil onto a piece of paper and transfer the dimensions to
the drywall patch piece.
4. Cut the patch piece just inside the traced lines. (Score the drywall paper with a box
cutter and then snap the drywall along the score line, then cut through the paper
on the back to get a clean line.)
5. Cut two pieces of mesh tape 1” longer than the patch piece. Cut two pieces 1”
shorter than the patch piece. The tape pieces should not overlap.
6. DR Prop should be assembled with the two parts screwed together. Insert it into
the hole. You may need to gently push insulation or wires out of the way. Center
DR Prop in the hole, remove the paper over the adhesive disc and press the flat
disc firmly against the back wall. Twist the front section of DR Prop until it is even
with the back side of the wall with the hole in it. Test fit your patch piece and
make any final adjustments to DR Prop so that your patch piece is flush and even
with the exterior wall.
7. Put the pieces of mesh tape over the cut edges, being careful to not overlap the
tape.
8. Prepare the compound using 2 parts compound to 1 part water. Mix up half of
compound at a time.
9. Carefully use the putty knife to apply the compound over the mesh tape and skim
across the patch with thin even coats. Allow to dry. Repeat with other half of
compound.
10. Allow to dry completely. Use sandpaper to even out the surface. Your repair can
be painted or textured to match existing wall.
Clarke Home Products, Inc.
204 37
th
Ave N. Suite 114
St. Petersburg, FL 33704