Guide

www.DrRobot.com

- 11 -

Robot Operations

Step 1: If you have not installed the programs, insert the installation CD to

CDROM and run the “Setup.exe” program which under “Sputnik-III Control

Installation” folder to a PC (called server PC), set your PC IP to

192.168.0.104, Gateway: 192.168.0.200 and Subnet Mask

255.255.255.0.

Step 2: Connect the server PC to the wireless router (one of the LAN ports)

(the router has IP 192.168.0.200) included in the package.

Step 3: Position the robot head to the rest position as shown on the right.

This is VERY IMPORTANT for your and robot’s safety.

Step 4: Turn on the robot main power switch on the back. NOTE: Always

keep a safe distance from the robot.

Step 5: Run the “DrRobotMotionPowerControl” from Start -> All Programs -

> Dr Robot Inc -> Sputnik-III Control -> DrRobotMotionPowerControl. The

“DrRobotMotionPowerControl” connect to robot via the DrRobotMotion

gateway & DrRobotPower gateway programs. It requires robot information

which can be found in “Networking Connection and Login Information”

section. After entering or confirming the information, then click “Connect Robot”.

Two gateway programs will be called up to establish communication connections with the electronic system on

the robot.

IP of the Robot WiFi module 1

IP of the Robot WiFi module 2

for indoor GPS System

(optional)