Service manual

3-92 FUEL SYSTEM (DFI)
Air Cleaner
Air Cleaner Elemen t Removal
•
Remove:
Seat (see Seat Removal in the Frame chapter)
Clips [A]
Air Cleaner Housing Cap [B]
•
Remove:
Element Holder Screws [A]
Element Holder [B]
Element [C]
•
After removing the element, stuff pieces of lint-free, clean
cloth into the air c leaner ducts to keep dirt out of the throt-
tle body assy and engine.
WARNING
If dirt or dust is allowed to pass through into the
carburetors, the throttle may become stuck, possi-
bly causing an accident.
CAUTION
If dirt gets through into the engine, excessive en-
gine wear and possibly engine damage will occur.
Air Cleaner Elemen t Installation
•
Install:
Element
Element Holder
•
Tighten:
To rque - Air Cleaner Ele ment Holder Screw: 3.5 N·m (0.36
kgf·m, 31 in·lb)
Air Cleaner Element Holder Tapping Screw: 1.5
N·m (0.15 kgf·m, 13 in·lb)
•
Fit the tangs [A] of the housing cap into the guides [B].
Air Cleaner Element Cleaning and Inspection
•
Refer to the Air Cleaner Element Cleaning and Inspection
in the Periodic Maintenance chapter.
Air Clean er Housing Removal
•
Remove:
Air Cleaner Element (see Air Cleaner Element Removal)
Spark Arrester [A]
Side Covers (see Left and Right Side Cover Removal in
the Frame chapter)