Service manual

2-18 PERIODIC MAINTENANCE
Periodic Maintenance Procedures
•
Twist the screwdriver to disconnect the joint lock [A].
•
Pull the fuel hose joint [B] out of the delivery pipe.
WARNING
Be prepared for fuel spillage; any spilled fuel must
be completely wiped up immediately.
When the fuel hose is disconnected, fuel spills out
from the hose and the pipe. Cover the hose connec-
tion with a clean shop towel to prevent fuel spillage.
•
Install the new fuel hose.
•
Insert the fuel hose joint [A] straight onto the delivery pipe
until the hose joint clicks.
•
Push [B] the joint lock [C].
•
Push and pull the fuel hose joint [A] back and forth more
than two times and make sure it is locked and doesn’t
come off.
WARNING
Make sure the fuel hose joint is installed correctly
on the delivery pipe or the fuel could leak.
If it comes off, reinstall the hose joint.
•
Run the fuel hose correctly (see Cable, Wire and Hose
Routing section in the Appendix chapter).
•
Install the removed parts (see appropriate chapters).
•
Start the engine and check the fuel hose for leaks.
Cooling System
Radiator Cleaning
CAUTION
Clean the radiator screen and the radiator in ac-
cordance with the Periodic Maintenance Chart.
In dusty areas, they should be cleaned more fre-
quently than the recommended interval. After
riding through muddy terrains, the radiator screen
and the radiator should be cleaned immediately.