Operating instructions

56 16.50 PRO DR

RAPID-FEED™ CHIPPER

11. Slide a Wheel Assembly onto the Axle Shaft. Make

sure the open side of the Wheel Hub with the loose

Taper Bearing is facing towards you (Figure 60).

12. Screw the Castle Nut onto the Axle and tighten it with

an adjustable wrench to seat the Bearings (Figure 61).

13. Back the Castle Nut off and then snug it up to the

Bearing lightly.

14. Insert a Cotter Pin through the slots of the Castle Nut

and into the hole in the Axle.

15. Bend the ends of the Cotter Pin with Needle nose

Pliers to secure it.

16. Place the Dust Cap onto the Wheel Assembly and

secure it by placing a piece of wood over it and

pounding lightly with a hammer until it is against the

lip (Figure 62).

17. Jack the back of the Chipper up and remove the jack

Stands.

18. Lower the Chipper to the ground.

19. Check the Tire for proper air pressure of 60 psi

maximum in each Tire.

ure 60

Wheel

Assembly

Taper

Bearing

ure 61

Castle

Nut

Cotter Pin

ure 62

Wheel

Assembly

Dust Cap