Operating instructions

Installing the Tail Lights:

1. Push the Yellow/Brown and Green/Brown Wires of

the Wire Harness through the hole in the front left

side of the Frame (Figure 63).

2. Pull the Wires to the back of the Chipper Frame. Pull

the Yellow/Brown Wires up through the Wire Hole on

the left rear of the Frame (Figure 64). Do not pull the

Wires through the Bracket Holes.

3. Pull the Green/Brown Wire up through the Wire Hole

in the right rear of the Frame.

4. Strip 1/2" of insulation from the ends of the

Yellow/Brown wires and Green/Brown wires and twist

the individual wire ends to aid in installation.

NOTE: Ensure that you have the correct Light for each side.

The Side Light of each Light Assembly must face to

the outside of the Chipper.

5. Push the Yellow Wire into the top left hole in the back

of the light socket and push the Brown Wire into the

top right hole (Figure 65).

NOTE: The wires will be connected and retained in the light

socket holes by spring-loaded connections.

6. Push the Green Wire into the top right hole in the

back of the light socket and push the Brown Wire into

the top left hole.

Brown

Wire

Figure 65

Yellow

Wire

Side

Light

Wire

Harness

Figure 63

Hole in

Frame

Light

Bracket

Holes

Figure 64

Wire

Hole

Rear of

Frame

Left Side

of Frame