User guide

Important Safety
In
f
o
r
mat
i
on
4A. Important Safety Information 223
population. The guidelines are based on the safety standards previously set by both U.S. and
international standards bodies:
䢇 American National Standards Institute (ANSI) IEEE. C95.1-1992.
䢇 National Council on Radiation Protection and Measurement (NCRP). Report 86. 1986.
䢇 International Commission on Non-Ionizing Radiation Protection (ICNIRP) 1996.
The exposure standard for wireless mobile phone employs a unit of measurement known as
the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg*.
The FCC has granted an Equipment Authorization for this model device with all reported
SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR
information on this model device is on file with the FCC and can be found under the Display
Grant section of
https://fjallfoss.fcc.gov/oetcf/eas/reports/GenericSearch.cfm after searching on
FCC ID: NM8RHOD400. Additional information on Specific Absorption Rates (SAR) can be
found on the Cellular Telecommunications & Internet Association (CTIA) website as
http://
www.phonefacts.net.
* In the U.S., the SAR limit for mobile phone used by the public is 1.6 Watts/kg (W/kg)
averaged over one gram of tissue. The standard incorporates a substantial margin of safety
to give additional protection for the public and to account for any variations in usage.
Normal condition only to ensure the radiative performance and safety of the interference. As
with other mobile radio transmitting equipment, users are advised that for satisfactory
operation of the equipment and for the safety of personnel, it is recommended that no part of
the human body be allowed to come too close to the antenna during operation of the
equipment.
Body-worn Operation
This device was tested for typical body-worn operations. To comply with RF exposure
requirements, a minimum separation distance of 1.5 cm must be maintained between the
user’s body and the handset, including the antenna. Third-party belt-clips, holsters, and
similar accessories used by this device should not contain any metallic components. Body-