www.dragino.com HP0DA Light Hotspot for Helium User Manual Document Version: 0.1 Firmware Version: Version 0.
www.dragino.com Table of Contents 1 2 Introduction .............................................................................................................................. 3 1.1 What is HP0A.............................................................................................................................. 3 1.2 Specifications.............................................................................................................................. 3 1.3 Features ...................
www.dragino.com 1 Introduction 1.1 What is HP0A The HP0A is a full hotspot for Helium. User can connect their sensors to Helium network via HP0A. 1.2 Specifications Hardware System: Linux Part: H3 Interface: 10M/100M RJ45 Ports x 1 LoRaWAN Wireless Power Input: 12V 1A, DC Operating Condition: 1.
www.dragino.com 1.
www.dragino.com 2 2.1 How to use Get IP Address Connect the HP0D Ethernet port to your router and HP0D will obtain an IP address from your router. In the router’s management portal, you should be able to find what IP address the router has assigned to the HP0D. You can use this IP to connect the WEB UI or SSH access of HP0D. 2.
www.dragino.com 2.6 Installation of Antenna HP0D use Fiber Glass Antenna. User need to connect antenna cable’s SMA connector to the HP03 and connect N-Type connector to antenna and install as below: 3 Manufacturer Info Shenzhen Dragino Technology Development co. LTD Room 202, Block B, BCT Incubation Bases (BaoChengTai), No.
www.dragino.com 4 FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
