User's Manual

User Manual for LoRaWAN End Nodes - LA66 LoRaWAN Module User Manual
Page 8 / 8
Integration instructions for host product manufacturers according to
KDB 996369 D03 OEM
Manual v01
2.2 List of applicable FCC rules
modular.
2.3 Specific operational use conditions
This module is stand-alone modular. If the end product will involve the Multiple
simultaneously transmitting
condition or different operational conditions for a
stand-alone modular transmitter in a host
,
host manufacturer
have to consult with module
manufacturer for the installation method in end system.
2.4 Limited module procedures
Not applicable
2.5 Trace antenna designs
Not applicable
2.6 RF exposure considerations
To maintain compliance with FCC's RF Exposure guidelines, This equipment should be
installed and operated
with minimum distance of 20cm from your body.
2.7 Antennas
This radio transmitter FCC ID: ZHZLA66 has been approved by Federal
Communications Commission
to
operate with the antenna types listed below, with the
maximum permissible gain indicated.
Antenna types not included in this list that have a gain greater than the maximum gain indicated
for any
type
listed are strictly prohibited
for use with this device.
CFR 47 FCC PART 15 SUBPART A and C has been investigated. It is applicable to the
2.8 Label and compliance information
The final end product must be labeled in a visible area with the following" Contains
FCC ID: ZHZLA66
2.9 Information on test modes and additional testing requirements
Host manufacturer is strongly recommended to confirm compliance with FCC
requirements for the transmitter when the module is installed in the host.
2.10 Additional testing, Part 15 Subpart B disclaimer
Host manufacturer is responsible for compliance of the host system with module installed
with all other applicable requirements for the system such as Part 15 B
Stick antenna