User's Manual

Safety and Regulatory Compliance

Version 1.0

2.1.4. Electrocution Hazard

Warning

Electrocution Hazard

This product is intended to be connected to a –48v dc power source (supplied by

DragonWave Inc.), which must be electrically isolated from any ac sources and

reliably connected to Earth ground. Do not install DragonWave products near any

type of power line. Should your antenna or related hardware come in contact with

power lines, severe bodily harm or death could result!

2.2. Regulatory Compliance Information

This section contains information regarding regulatory compliance with the

Federal Communication Commission, Department of Communications and the

European Telecommunications Standards Institute applies to the DragonWave

AirPair

Radio Link.

2.2.1. Federal Communication Commission Declaration of Conformity

Statement

This device complies with Part 15 of FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference,

and (2) This device must accept any interference received, including interference

that may cause undesired operation.

This equipment has been tested and found to comply with the limits of a Class B

digital device, pursuant to Part 15 of FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation. This equipment generates and can radiate radio-frequency energy

and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures.

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and receiver

• Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected

• Consult the dealer or an experienced radio/TV technician for help

Any changes or modifications not expressly approved by the party responsible

for compliance could void the user’s authority to operate the equipment.