User's Manual

7. Setting up the SNMP
Procedure 7-1
Setting up SNMP
Perform this procedure to set up SNMP for the AirPair.
Required Action Steps
telnet Telnets to the AirPair.
set snmp access mode
[v1/v2c/off]
Selects a mode.
Sequence:
set snmp access mode [v1/v2c/off] press Enter
The system responds:
SNMP Mode: [v1 | v2c | off]
set snmp set request [on/off] Sets the SNMP access on. This allows SNMP v1 and v2c ‘Set’
requests.
Sequence:
set snmp set request [on/off] press Enter
The system responds:
SNMP Set Requests are [on/off].
get snmp set request Displays SNMP requests on. Shows if SNMP v1 and v2c ‘Set’
requests are enabled. The default is off.
Sequence:
get snmp set requests press Enter
The system responds:
SNMP Set Requests are [on | off].
get snmp managers Displays a list of managers that can access the system via SNMP.
Sequence:
get snmp managers press Enter
The system responds:
Mgr # IpAddress/ CommunityString