User's Manual

Initial Configuration

Horizon Compact Release 1.01.01 Wireless Ethernet Product User Manual – Volume 1

6. To reduce the throughput speed to a figure less than the licensed speed, use the CLI

command set system speed <speed>, where<speed> is in Mbps and can be adjusted

in 1 Mbps increments.

7. Type the CLI command get frequency bank and press Enter. A list of frequencies is

displayed.

8. Licensed only - Locate the frequencies on the displayed list that match those found on

the wireless license documents, and note the index number/letter on the left of the list

(case sensitive)

9. Unlicensed only – The displayed list will show “Go” and “Rt” frequencies. One end of

the link must be configured with a “Go” frequency and the other configured with the

corresponding “Rt” frequency. Either end of the link can be configured as “Go” or “Rt”.

10. Type the CLI command set programmed frequency <index number/letter> and press

Enter, where <index number/letter> is the same as that found in step 8 for licensed, or

step 9 for unlicensed, installations

11. Unlicensed only – Determine the size (in cm) of antenna to be used with your

unlicensed system. Type the CLI command get antenna size and press Enter. The

allowable antenna sizes are displayed, along with a corresponding index number. Note

the index number that corresponds to the size of antenna to be installed.

12. Unlicensed only - Type the CLI command set antenna size <index number> and

press Enter, where <index number> is the index number determined in step 11.

13. Type the CLI command save mib and press Enter. This command saves the entered

information to memory, but does not yet apply it.

Note: You will need to issue the CLI command reset system to apply the changes and make them

effective. Optionally, this can be left until all the initial configuration parameters have been entered before

issuing the command (See 6.3.1 step 5).

6.2.2 Using the Web interface

1. From the Home page select the “Configuration” menu option and then select the

“Frequency and port configuration” option

2. Use the drop down menus on the Web page for entering or changing the radio band

and the programmed frequency. For licensed systems, the frequency bank “txLow” or

“txHigh” will be pre-determined (HIGH or LOW Horizon label)

3. Return to the “Configuration” menu and select the “System Configuration” option

4. Use the drop down menu to select the desired system mode

5. click on the “Save settings” button

Note 1: For unlicensed systems, you cannot configure antenna size using the Web interface.

Note 2: You will also need to click on the “Reset system” button to make these entries effective.

Optionally, this can be left until all the initial configuration parameters have been entered before issuing

the command (See 6.3.2 step 5).