User's Manual
DragonWave Inc.
64
Horizon Compact Release 1.01.01 Wireless Ethernet Product User Manual – Volume 1
12.9 Alarms List
Use the CLI command get alarms to display a list of active alarms. Alternatively, alarms are listed on the
Alarms page of the Web interface. Active alarms are clearly indicated.
The following list shows the various alarms available:
• Explicit Authentication Failed
• Ethernet Link Down
• Dropped Ethernet Frame Threshold Exceeded
• Bandwidth Utilization Threshold Exceeded
• Modem hardware fault
• Modem receiver loss of signal
• Modem SNR below threshold
• Modem programming error
• Modem transmitter loss of sync
• Modem equalizer stress above threshold
• Radio RSL Below Threshold
• SNTP Servers Unreachable
• RLS Shutdown Activated
• AAM Config mismatch
• Tx power detector below threshold
• Radio current out of limits
• TempComp cal table not available
• Radio temperature out of limits
• Radio Power Amplifier
• ATPC Config Mismatch
• RLS Mismatch
• Frequency File invalid
• AAM running on QPSK modulation
• Synthesizer Unlock