User's Manual

System Management

101

Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 2

To configure the management interface use the following procedure:

Procedure 17-1

Configuring Network Management Interface

Required Action

Steps

Configure network

management interface

This command sets the port on which management traffic will be carried

and also the type of network management – in-band, or out-of-band.

Select either dp1 through dp4 for in-band management, or p1 through p4

for out-of-band management.

The following example changes the network management interface from

in-band on dp3 to out-of-band on p1.

Ensure that there is an associated physical connection for the port

selected.

Note that if you change the management port you will need to reconnect

your PC to the new active port.

Sequence :

set network management interface press Enter

The system responds:

#Press 'Ctrl-X' to exit config process

#Press 'Enter' to retain previous value (shown in brackets)

Port Name (dp3) ? p1

Would you like to save MIB ? Enter Y(Yes) or N(No):y

Apply the setting to system immediately.This operation may cause the

loss of current connection!

Continue? Enter Y(Yes) or N(No)y

Mib saved successfully.Configuring management interface...

Config Name User Config Running Config

--------------- ------------- --------------

Port Name : p1 p1

Note: it is recommended that when using out-of-band management

that the port payload state of the port concerned is set to “disabled”.

See Section 4.0 Configuring Ethernet Ports 1 and 2.