User's Manual

System Management
103
Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 2
17.2 Telnet Access
Once correctly configured, the Horizon Compact Plus is accessible through a Telnet session using Super
User, NOC and Admin level user accounts. Refer to Volume 1 for details of CLI commands. The Horizon
Compact Plus system can be completely configured, tested and managed through a Telnet session. The
Telnet function is enabled by default but can be disabled within the Horizon Compact Plus system.
Procedure 17-2
Configuring Telnet Access
Required Action
Steps
login
Log in as the Super User.
View telnet access
Returns the status of Telnet access (on by default)
Sequence :
get telnet access press Enter
The system responds:
telnet access is [on/off]
Configure telnet access
Enables or disables Telnet access.
Sequence :
set telnet access [on/off] press Enter
The system responds:
telnet access is [on/off]
Save changes to mib
Saves the MIB to RAM. Perform this command to save configuration
changes to non-volatile memory.
Sequence:
save mib press Enter
The system responds:
MIB saved successfully.