User's Manual

Network Management
133
Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 2
Required Action
Steps
View snmpv3 trap
hosts
Displays a list of configured SNMPv3 trap hosts
Note that only the Super user can view the ip addresses of trap hosts.
Sequence:
get snmpv3 trap hosts press Enter
The system responds:
# IpAddress UserName Auth Auth Priv Priv TrapHost
Proto Passwd Proto Passwd Enabled
= =============== =============== ===== ===============
1 192.168.4.254 guest None - None - y
2 0.0.0.0 None - None - n
3 0.0.0.0 None - None - n
4 0.0.0.0 None - None - n
5 0.0.0.0 None - None - n
Configure snmpv3 trap
host ip
To set the trap host ip address to capture v3 traps. This will only set up a trap
host destination without authentication or privacy.
NOTE: You must set a trap host user (see next command) before a
configured trap host will function. Only Super user is allowed to set these
parameters.
Sequence:
set snmpv3 trap host ip <index> <ipAddr> press Enter
where <index> indicates which trap host entry you want to set in the
range of 1...5 and <ipAddr> is the ip address of the host on the network.
The system responds:
Save mib and reboot Horizon Compact Plus for changes to take effect.
Configure snmpv3 trap
host user
To set the host user name associated with v3 trap hosts. This will only set up
a trap host destination without authentication or privacy.
NOTE: You must set a trap host ip (see previous command) and a host user
name before a configured trap host will function. Only Super user is allowed
to set these parameters.
Sequence:
set snmpv3 trap host user <index> <userName> press Enter
where <index> indicates which trap host ip address entry to which you
want to add the host user name in the range of 1…5
The system responds:
Save mib and reboot Horizon Compact Plus for changes to take effect.