User's Manual

Network Management
139
Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 2
Required Action
Steps
Configure snmp trap
[trapIndex] [enable/disable]
Enables or disables SNMP traps. DragonWave recommends enabling trap 16.
This trap indicates loss of communication with the peer Horizon Compact Plus
node.
Sequence:
set snmp trap [trapIndex] [enable/disable]
Example (enabling trap 16):
set snmp trap 16 enable press Enter
The system responds:
Trap# TrapName Enabled(Yes | No)
1 Link down No
2 Peer authentication failure No
3 HAAM configuration mismatch No
4 HAAM operating in lower modulation No
5 ATPC configuration mismatch No
6 ATPC auto disabled No
7 SNTP server(s) unreachable No
8 Frequency file invalid No
9 Aggregate dropped frame threshold No
10 Queue dropped frame threshold No
11 Bandwidth utilization threshold No
12 Queue depth threshold No
13 RLS configuration mismatch No
14 RLS shutdown activated No
15 RLS queue based shutdown No
16 Modem receiver loss of signal Yes
17 Modem SNR below threshold No
18 Modem equalizer stress above limit No
25 Partner configuration mismatch No
26 Active on secondary No
27 Operating in forced switch mode No
28 Enet cross link active No
29 Active using partner wireless link No
30 Standby wireless link is in use No
31 Standby on primary No
32 X2 delivering half the capacity No
33 BNC cable signal not detected No
34 Ethernet speed reduced No
35 SyncE lost lock No
36 SyncE secondary source in use No
37 Invalid system configuration No
38 MIB change not saved No
39 Transmitter loss of sync No
41 Cold start No
42 User session No
43 HAAM event No