User's Manual

DragonWave Inc.
150
Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 2
CLI Command
Description
get peer authentication failure action
returns action taken by the system on peer authentication
failure.
get peer authentication group key
returns group authentication key.
get peer authentication status
returns status of Authentication in the system.
get peer authentication type
returns the type of authentication used to authenticate the
peer.
get peer authentication unique key
returns serial number (as entered in the set command) of
peer system with which system communicates within
UNIQUE authentication mode.
get performance log
gets the performance log
get performance log interval
gets the performance logging interval.
get performance logging
displays performance logging is enabled or not.
get port eoam event-log [port <1-2>]
Displays EOAM event logs.
get port eoam event-notifications [port <1-
2>]
Displays EOAM event notifications.
get port eoam fault-management config
port <1-2>
Displays EOAM link event actions and max desciptors per
variable request.
get port eoam fault-management mib-
variable response port <1-2>
Displays MIB variable response.
get port eoam fault-management remote-
loopback [port <1-2>] [current-session |
last-session] [detail]
Displays EOAM loopback statistics.
get port eoam local information [port <1-
2>]
Displays ethernet OAM local information.
get port eoam loopback capability[port <1-
2>]
Display EOAM Looback capabilities.
get port eoam neighbour information [port
<1-2>]
Displays EOAM neighbour information.
get port eoam statistics [port <1-2>]
Displays EOAM statistics counter.
get programmed frequency
returns RX IF, RX RF, TX IF,and TX RF frequencies after
setting the programmed frequency.
get qos
return value indicates whether the dot1p qos is 'on' or 'off'.
get qos policy
return the qos policy [strict_priority or wfq].
get queue utilization threshold
returns the thresholds for the Queue Depth trap
get radio band
gets the radio frequency band in use in the system.
get radio config
returns a list of radio configuration parameters
get radio loopback
gets the radio loopback status [on | off].
get radio statistics
returns radio statistics in the system.
get radio status
returns the radio alarms and synthesizer status.