User's Manual

Detailed CLI Command List
157
Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 2
CLI Command
Description
set ecfm service <{[config]
<service_name> [{icc <icc_code> umc
<umc_code>] [vlan <vlan-id(1-4094)>]
[mip-creation-criteria {none | default |
explicit | defer}] [sender-id-permission
{none | chassis | manage | chassis-mgt-
address | defer}]}>| <{delete
<service_name>
Configures the provided Service (Maintenance
Association) at the specified vlan. User can configure ICC
and UMC when Y.1731 is enabled.
set ecfm traceroute cache [ on|off | {
holdtime { default | <integer(1-65535)} }
on - Enables Linktrace replies (LTR) caching, by
default it is disabled. off - Disables Linktrace
replies (LTR) caching. Traceroute cache (LTR
Table) should be empty before it can be disabled. holdtime
- Sets Linktrace replies (LTR Table) maximum age.
holdtime default - resets the age to 100 minutes.
- Traceroute caching should be enabled.
Traceroute caching should be enabled and cache should
be empty.
set ecfm y1731 [on | off ]
Enables(on) or disables(off) Y.1731 processing globally on
a device. For Y.1731 to be enabled, ECFM should be
enabled.
set enet config
Configures the characteristics of the specified Ethernet
port. This is an interactive command
set enet speed port[port1 | port2]
speed[10|100|1000|auto] AutoNeg[auto]
Sets the ethernet speed for the specified port. Last
argument AutoNeg is optional
set enet speed alarm enable port1|port2
on|off
Enables or disables the enet speed alarm for either port 1
or port 2.
set eoam [on | off]
Enable or disable EOAM on the system.
set eoam dwi-msg mode [eoam | bypass-
eoam]
Set the DWI specific msg type for eoam .
set eoam fault-management [on | off | start]
Enable/Disable fault management on the system.
set eoam link-monitor event-resend
[count(1-10)]
Specify resend count of OAM PDUs to send for event
notification. Default count for OAM PDUs is 10.
set eoam oui [<aa:aa:aa> | default]
Configure the Organization Unit Identifier (OUI). Default
sets the OUI to the Switch Base Mac address.
set haam[on/off]
Set Hitless Adaptive Modulation(HAAM) on or off.
set haam eoam option
enables the system to send eoam messages when haam
changes modulation schemes.
set haam manual mode[on|off]
Set Hitless Automatic Adaptive Modulation(haam) manual
mode on or off.
set haam wtr[duration]
Set the duration in seconds that Hitless Adaptive
Modulation (HAAM) waits before shifting to a higher rate
mode.
set http secure access [Admin|Noc|Super]
[on/off]
Set the HTTP Secure access to a group of users on or off.
set ip address [abc.def.ghi.jkl]
sets the system ip address.