User's Manual

DragonWave Inc.
158
Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 2
CLI Command
Description
set ip config
Leads you through the steps to configure the ip
parameters
set lo nulling [on/off]
sets LO nulling params [on|off ,delay, step size, loop size].
set logging [on/off]
sets logging on [enabled] or off [disabled].
set maximum frame size [1600-9600]
sets the size of the maximum frame, range from 1600 to
9600
set network loopback [nearend | farend |
off] mac-address <queue N> <timeout>
sets the network loop back to near-end, far-end or off.
Ethernet packets destined for the specified MAC address
are looped back. The destination MAC (format
aa:aa:aa:aa:aa:aa) is required when enabling the loopback.
A user queue may be specified for use when QOS is
enabled.
set network management interface [p1, p2,
p3, p4, dp1, dp2, dp3, dp4]
sets the port used for managing the system. p1 – p4 out-
of-band. dp1 – dp4 in-band.
set noc user
allows the user to set up NOC account. Username and
Password cannot be empty.( Max 5 NOC accounts are
allowed).
set optical transmitter state [on/off]
sets the state of the optical transmitter as 'on' or 'off'.
set pause state [on/off]
sets PAUSE (frames) on or off
set peer authentication failure action
[action]
configures the action to take on peer authentication
failure. [action] is either block_traffic or pass_traffic.
set peer authentication group key [key]
writes a group authentication key. [key] is a 32 character
alpha numeric.
set peer authentication type [authentication
type]
sets the authentication type of the air interface.
[authentication type] is one of the following: none, unique,
group
set peer authentication unique key [key]
stores serial number of peer system that the system will
be communicating with.
set performance log interval [hr:min:sec]
sets the performance log interval.
set performance logging
sets the performance logging on[enabled] or off [disabled].
set port eoam [port <1-2>] [on | off]
Enable EOAM on port.
set port eoam fault indication [port <1-2>]
[critical-event | dying-gasp] [on | off]
Enabling/disabling critical event or dying gasp fault
indication.
set port eoam fault-management action
[port <1-2>] [critical-event | dying-gasp |
link-fault] [none | warning]
Specifying the action for the critical events received from
local.
set port eoam fault-management link-
monitor action [port <1-2>] [frame | frame-
period | frame-sec-summary] [none |
warning]
Specifying the action for the link monitoring threshold
crossing events received from local.
set port eoam fault-management mib-
request [port <1-2>]
<branchleaf:branchleaf:...>
Send MIB variable request to peer.