User's Manual

Detailed CLI Command List
161
Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 2
CLI Command
Description
set rls shutdown policy [port-down/eoam-
msg]
sets the RLS shutdown notification policy to either EOAM
messages or port shutdown.
set rls signal fault parameters [fault period
msec] [fault threshold]
sets the RLS signal fault monitor parameters, where [fault
sample period msec] : sample period to apply Fault
Threshold ratio [fault threshold percentage]: ratio of 'fault
sample period' faulted before link is shut down.
set rsl threshold [threshold] [time limit]
sets the RSL threshold for the system. The time that the
threshold must be crossed in order for itbe considered an
alarmable/trappable event is specified by the user. The
default time limit is 10 secs.
set snmp access mode [v1|v2c|off]
specifies whether SNMP v1 and v2c requests are
enabled.
set snmp manager [Mgr Index] [ipAddress]
[enable|disable] [communityString]
adds a SNMP manager to the list of allowed SNMP
managers of the system.
set snmp set request [on|off]
allows SNMP 'set' requests.
set snmp trap [trap#] [enable|disable]
enables or disables particular SNMP trap in the system.
set snmp trap host [host#] [ipAddress]
[enable|disable] [communityString]
adds an SNMP trap host to the list of receivers of snmp
traps.
set snmpv3 manager
adds a SNMP v3 manager to the list of allowed SNMP v3
managers of the system.
set snmpv3 trap host authentication [index]
[none|md5|sha] [passwd]
set the authentication protocol and password for an
snmpV3 trap host
set snmpv3 trap host disable [index]
disable an snmpV3 trap host.
set snmpv3 trap host enable [index]
enable an snmpV3 trap host.
set snmpv3 trap host ip [index] [ipAddress]
set the IP address of an snmpV3 trap host.
set snmpv3 trap host privacy [index]
[none|des]
set the privacy protocol and password for an snmpV3 trap
host
set snmpv3 trap host user [index]
[userName]
set the user name of an snmpV3 trap host.
set snr threshold [SnrThreshold]
configures the SNR threshold. SNR Threshold is an
integer.
set sntp [on|off]
turns SNTP on or off
set sntp default
sets SNTP to default settings: SNTP is on, factory set
default SNTP servers are used, 10 minute polling. SNTP
time offset is not altered.
set sntp offset
sets the SNTP time offset in hours: the regional time
minus Greenwich Mean Time; used to calculate and set the
system time
set sntp server
writes one SNTP server, based on the index selected
set ssh server
turns the SSH server on or off.
set subnet mask [abc.def.ghi.jkl]
sets the system subnet mask.