User's Manual

DragonWave Inc.
162
Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 2
CLI Command
Description
set super user
allows the user to change the Super Username and
Password. Username and Password cannot be empty.
set synce forced holdover
This is a user troubleshooting command which forces the system
into holdover mode for a configurable timeout value (time) in
seconds. The default timout is 30 seconds. Values can be 0 to
300 seconds. 0 keeps the holdover on indefinitely.
set synce member port [p3-p8|wp1|wp2|freerun]
This command allows you to add all the ports that are required to
handle SynchE into the member port group. Note that in order to
configure the ports that are to be the primary and secondary clock
sources, the ports must first be made part of the member port
group.
set synce mode [off|manual|auto]
Use this command to enable SyncE. Select manual when you
want the system to go into holdover when the primary clock
source fails. If the primary source recovers, the system will
automatically switch back to the primary source. Select auto if you
want the system to switch to the secondary clock source if the
primary clock source fails. In auto the system will not switch back
to the primary if the primary clock recovers, unless set synce
revertive is enabled.
set synce primary source [p3-
p8|wp1|wp2|freerun]
This command allows you to select which port is to be the primary
clock source. Note that the port must be configured as a GigE port
(1000 Mbps). Note, also, that ports p1 and p2, being SFP ports
cannot be used as a clock source.
set synce revertive [on|off] [time]
This command allows you to enable or disable the revertive mode.
On a primary clock source failure and provided that the SyncE
mode is configured for auto, when revertive mode is enabled (on),
it allows the system to automatically revert back from the
secondary to the primary clock source, once the primary clock
source has recovered and remains stable for a selected time in
seconds. The default time is 10 seconds.
set synce secondary source [p3-
p8|wp1|wp2|freerun]
This command allows you to select the port that will provide the
secondary clock source. It will take over from the primary clock
source if the primary clock source fails. Note that unless the
revertive feature is enabled (set synce revertive on), if, after a
switch to the secondary clock source, the primary clock source
recovers, the system will not automatically switch back from
secondary to the primary clock source.
set synce wander filter [option1|option2]
This command allows the user to select either Ethernet
Equipment Clock filter Option 1, or Option 2. Option 1 would be
used in the E1 TDM hierarchy and Option 2 in the T1 TDM
hierarchy.
set syslog forwarding [on|off]
set syslog forwarding on or off. Syslog will start forwarding
messages to specified host when turned 'on'
set syslog forwarding host [ipAddress]
set the syslog forwarding host IP Address.
set system current speed [speed]
sets the current speed in Mbps.
set system mode [system mode name]
sets the system mode.
set telnet [on|off]
enables or disables the Telnet Access to the user.
(Access: Only through Serial Port)
set traffic statistics [0]
clears all traffic statistics, including extended statistics to
0. Only parameter accepted is '0'.