User's Manual

DragonWave Inc.
16
Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 2
Required Action
Steps
Configure ports
The second example configures physical Port 2 with two 100/10 Base-t circuits p2 and p3.
Note that p1 has already been configured as a GigE port as per the first example, which
leaves p4 disabled. After configuring p2, repeat the procedure for p3.
Sequence:
set enet config and press Enter
The system responds:
#Press 'Ctrl-X' to exit config process
#Press 'Enter' to retain previous value
Port Id[P(1-4)] (1) ? 2
Port Description ():
Auto Negotiation [ on(1) | off(2)] (on):
Speed Mbps [10 (1) | 100 (2) | 1000(3) | auto(4)] (100):
Maximum Frame Size (1600):
Port Payload State [enable(1) | disable(2)] (disable):
Port Admin state [on(1) | off(2)] (on):
Apply the above settings ? Enter yes(y) or no(n)y
---------------------------------------------------------------------------------------------------------------------------
ETHERNET PORT CONFIGURATION
======================================================================
Enet Port ID :P1
Port Descriptor :AnyName
Auto Negotiation :on
Port Medium :auto
Optical Tx State :on
Speed :auto
Auto Mdix :on
Pause Frame Enable :off
Max. Frame Size :1600
Payload State :enable
Admin State :on
Enet Port ID :P2
Port Descriptor :AnyName
Auto Negotiation :on
Speed :auto
Auto Mdix :on
Pause Frame Enable :off
Max. Frame Size :1600
Payload State :enable
Admin State :on
Enet Port ID :P3
Port Descriptor :AnyName
Auto Negotiation :on
Speed :auto
Auto Mdix :on
Pause Frame Enable :off
Max. Frame Size :1600
Payload State :enable
Port State :off
Admin State :on
Enet Port ID :P4
Port Descriptor :AnyName
Auto Negotiation :on
Speed :auto
Auto Mdix :on
Pause Frame Enable :off
Max. Frame Size :1600
Payload State :disable
Port State :off
Admin State :on
Save changes to
mib
Saves the MIB to RAM. Perform this command to save setting changes to non-volatile
memory.
Sequence:
save mib press Enter
The system responds:
MIB saved successfully.