User's Manual

RADIUS Server Authentication

Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 2

Required Action

Steps

Select the port that will be the

primary (master)

synchronization clock source

This command allows you to select which port is to be the primary

clock source. Note that in order to configure the primary clock source

port, the port must first be made part of the member port group and be

configured as GigE (1000 Mbps), or 100BaseT (100 Mbps). Note, also,

that if port p1 is an SFP port it cannot be used as a clock source.

Sequence:

set synce primary source [p1|p2|p3|p4|wp1|freerun]

Example: set synce primary source wp1 press Enter

The system responds:

Synce mode : off

Primary clock source : wp1

Secondary clock source : freerun

Synce members : p4,wp1,freerun

Revertive mode : off

Wander filter option :option2

Select the port that will be the

secondary synchronization

clock source

This command allows you to select the port that will provide the

secondary clock source. It will take over from the primary clock source

if the primary clock source fails. Note that in order to configure the port

that is to be the secondary clock source the port must first be made

part of the member port group and be configured as GigE (1000

Mbps), or 100BaseT (100 Mbps). Note, also, that unless the revertive

feature is enabled (set synce revertive on), if, after a switch to the

secondary clock source, the primary clock source recovers, the

system will not automatically switch back from secondary to the

primary clock source.

Sequence:

set synce secondary source [p1|p2|p3|p4|wp1|freerun]

Example: set synce secondary source p4 press Enter

The system reponds:

Synce mode : off

Primary clock source : wp1

Secondary clock source : p4

Synce members : p4,wp1,freerun

Revertive mode : off

Wander filter option :option2