User's Manual

DragonWave Inc.

Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 2

Required Action

Steps

**For Weighted Fair

Queuing Only**

Enable the expedite queue

function

Enables or disables the expedite queue function.

When this option is enabled, the user also selects the desired number

of expedite queues. Up to four expedite queues can be configured.

The expedite queues will always be selected from Q8 through Q5.

Example: if the number of expedite queues is to be 4, Q8, Q7, Q6, and

Q5 will be the expedite queues and the rest will be WFQ. If the number

of expedite queues is to be 1, then only Q8 will be the expedite queue

and the rest will be WFQ.

The sum of the CIR of all WFQ queues should not exceed 100.

However the expedite queues can be allocated 0-100% bandwidth.

The behavior of the WFQ can not be guaranteed if the sum of the

CIR’s of all queues exceeds 100%.

Sequence:

set cos expedite queue [on/off][number of queues] press Enter

Example: set cos expedite on 2 press Enter

get cos expedite queue press Enter

The system responds:

Expedite queue is set to : on

Number of expedite queue is : 2

Expedite queue : q8, q7

**For Weighted Fair

Queuing Only**

Enable the Cut Through

queue as desired

This command enables or disables the Cut Through queue feature.

The expedite function must be enabled before this command can be

applied. The queue name must be any one of the configured expedite

queues q8 to q5

Sequence:

set cos cut through queue [on|off] [queue name (q8 – q5)] press

Enter

The system responds:

Cut through state is set to : on|off

Cut through queue is set to : q8 – q5