User's Manual

Rapid Link Shutdown
85
Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 2
Required Action
Steps
Configure Port Groups
This command determines what combination of port failures will
invoke RLS.
Sequence:
get rls port group press Enter
The system responds:
Rls port group configuration
Ports :P1 P2 P3 P4
Combination :any
The above response indicates that any one port P1 through P4 needs
to fail and RLS will be invoked.
set rls port group [p1[ [p2] [p3] [p4] [any|all] press Enter
Example 1:
set rls port group p1 p2 p3 p4 all press Enter
The system responds:
Rls port group configuration
Ports :P1 P2 P3 P4
Combination :all
The above response indicates that RLS will only be invoked when all
of ports P1 through P4 have failed.
Example 2:
set rls port group p3 any press Enter (“any” or “all” works for this
example)
The system responds:
Rls port group configuration
Ports : P3
Combination :any
If P3 fails RLS will be invoked.
Configure rls make rsl
This is an optional command. This command sets the minimum RSL
value required to re-establish, or “make”, the link.
Sequence:
set rls make rsl [RSL (dB)] [Duration (sec)] press Enter
The system responds:
RLS Make RSL Parameters: [RSL (dB)] [Duration (sec)]
Example: set rls make rsl -60.0 100
When the RSL level is maintain at -60.0 or a higher value (less
negative) for the duration of the sample period (100 seconds), the link
will be re-established.
Setting the RSL sample period to zero (0), the default value, disables
this feature.