User's Manual
Table Of Contents
- 1 Preface
- 2 Overview
- 3 Features
- 3.1 Main Features
- 3.2 Adaptive Coding and Modulation (ACM)
- 3.3 Transmit Power Control (TPC)
- 3.4 2x2 Multiple-input and Multiple-output (2x2 MIMO)
- 3.5 Dynamic Frequency Selection (DFS)
- 3.6 Dynamic Channel Selection (DCS)
- 3.7 Retransmission
- 3.8 Configurable Uplink/Downlink Ratio
- 3.9 Quality of Service (QoS)
- 3.10 Power over Ethernet
- 3.11 Synchronization
- 3.12 Co-site Synchronization
- 3.13 OFDM Modulation
- 3.14 Low-density Parity Check (LDPC) Encoding
- 3.15 LLDP
- 3.16 Radio Port Performance Monitoring
- 3.17 Adaptive Noise Immunity (ANI)
- 4 Mechanical Structure and Interfaces
- 5 Product Structure
- 6 Management
- 7 Technical Specification
- 8 Standards
35
DragonWave Inc. Mechanical Structure and Interfaces
The pinout definition is shown in the following table.
4.2.2 P+E Out (Eth 2) Interface
This is a P+E PSE interface which can be used to connect with collocated Lite at the
chain site. This interface can also be used for troubleshooting and installation in field.
Connector type
Shielded GE RJ45 8 pin gold plated contacts.
Suggested cable Shielded twisted pair (STP cat5e), at least 24 AWG wire
Power supply Works as P+E PD port. Lite can be fed by P+E PSE via this
port.
Pin Number Pin Function Power Pinout
1 pair A+ negative
2 pair A- negative
3 pair B+ negative
4 pair C+ positive
5 pair C- positive
6 pair B- negative
7 pair D+ positive
8 pair D- positive
Table 6 Pinout Definition of P+E In
Property Description
Table 5 P+E In
Property Description
Interface type 100/1000 Base-T
Duplex mode half and full with auto-negotiation or manual
Rate 100/1000 Mbit/s with auto-negotiation
MDI type auto sensing MDI/MDIX or manual
Front panel reference P+E OUT (ETH 2)
Table 7 P+E Out