User's Manual
Table Of Contents
- 1 Preface
- 2 Overview
- 3 Features
- 3.1 Main Features
- 3.2 Adaptive Coding and Modulation (ACM)
- 3.3 Transmit Power Control (TPC)
- 3.4 2x2 Multiple-input and Multiple-output (2x2 MIMO)
- 3.5 Dynamic Frequency Selection (DFS)
- 3.6 Dynamic Channel Selection (DCS)
- 3.7 Retransmission
- 3.8 Configurable Uplink/Downlink Ratio
- 3.9 Quality of Service (QoS)
- 3.10 Power over Ethernet
- 3.11 Synchronization
- 3.12 Co-site Synchronization
- 3.13 OFDM Modulation
- 3.14 Low-density Parity Check (LDPC) Encoding
- 3.15 LLDP
- 3.16 Radio Port Performance Monitoring
- 3.17 Adaptive Noise Immunity (ANI)
- 4 Mechanical Structure and Interfaces
- 5 Product Structure
- 6 Management
- 7 Technical Specification
- 8 Standards
36
DragonWave Inc.Mechanical Structure and Interfaces
The pinout definition is shown in the following table.
4.2.3 PoE+ In Interface (optional)
The optional PoE+ In interface is located with the Internal interface on the PoE+ module,
which is only required in the PoE+ application. The PoE+ In interface is a PoE+ PD port
that can be connected with an IDU which can work as PoE+ PSE.
Connector type
Shielded GE RJ45 8 pin gold plated contacts.
Suggested cable Shielded twisted pair (STP cat5e), at least 24 AWG wire
Power supply Works as P+E PSE port. It can feed to the second Lite at a
chain site.
Pin Number Pin Function Power Pinout
1 pair A+ negative
2 pair A- negative
3 pair B+ negative
4pair C+positive
5pair C-positive
6 pair B- negative
7pair D+positive
8pair D-positive
Table 8 Pinout Definition of P+E Out
Property Description
Table 7 P+E Out
Property Description
Interface type 100/1000 Base-T
Duplex mode half and full with auto-negotiation or manual
Rate 100/1000 Mbit/s with auto-negotiation
MDI type auto sensing MDI/MDIX or manual
Front panel reference PoE+ IN
Table 9 PoE+ In