User's Manual
Table Of Contents
- 1 Preface
- 2 Overview
- 3 Features
- 3.1 Main Features
- 3.2 Adaptive Coding and Modulation (ACM)
- 3.3 Transmit Power Control (TPC)
- 3.4 2x2 Multiple-input and Multiple-output (2x2 MIMO)
- 3.5 Dynamic Frequency Selection (DFS)
- 3.6 Dynamic Channel Selection (DCS)
- 3.7 Retransmission
- 3.8 Configurable Uplink/Downlink Ratio
- 3.9 Quality of Service (QoS)
- 3.10 Power over Ethernet
- 3.11 Synchronization
- 3.12 Co-site Synchronization
- 3.13 OFDM Modulation
- 3.14 Low-density Parity Check (LDPC) Encoding
- 3.15 LLDP
- 3.16 Radio Port Performance Monitoring
- 3.17 Adaptive Noise Immunity (ANI)
- 4 Mechanical Structure and Interfaces
- 5 Product Structure
- 6 Management
- 7 Technical Specification
- 8 Standards
37
DragonWave Inc. Mechanical Structure and Interfaces
The pinout definition is shown in the following table.
4.2.4 Internal Interface (optional)
This optional Internal interface is located with the PoE+ In interface on the PoE+ module,
which is only required in the PoE+ application. This interface is used to transfer power
and Ethernet traffic between PoE+ and P+E, when Lite is connected with PoE+ PSE via
PoE+ In interface.
Connector type
Shielded GE RJ45 8 pin gold plated contacts.
Suggested cable Shielded twisted pair (STP cat5e), at least 24 AWG wire
Power supply Works as P+E PD port. Lite can be fed by standard PoE+ PSE
via this port.
Pin Number Pin Function Power Pinout Alternatives
Alternative A Alternative B
1 pair A+ positive/negative -
2 pair A- positive/negative -
3 pair B+ negative/positive -
4 pair C+ - positive
5 pair C- - positive
6 pair B- negative/positive -
7 pair D+ - negative
8 pair D- - negative
Table 10 Pinout Definition of PoE+ In
Property Description
Table 9 PoE+ In
Property Description
Interface type 100/1000 Base-T
Duplex mode half and full with auto-negotiation or manual
Rate 100/1000 Mbit/s with auto-negotiation
Front panel reference INTERNAL
Table 11 Internal