User's Manual
Table Of Contents
- 1 Preface
- 2 Overview
- 3 Features
- 3.1 Main Features
- 3.2 Adaptive Coding and Modulation (ACM)
- 3.3 Transmit Power Control (TPC)
- 3.4 2x2 Multiple-input and Multiple-output (2x2 MIMO)
- 3.5 Dynamic Frequency Selection (DFS)
- 3.6 Dynamic Channel Selection (DCS)
- 3.7 Retransmission
- 3.8 Configurable Uplink/Downlink Ratio
- 3.9 Quality of Service (QoS)
- 3.10 Power over Ethernet
- 3.11 Synchronization
- 3.12 Co-site Synchronization
- 3.13 OFDM Modulation
- 3.14 Low-density Parity Check (LDPC) Encoding
- 3.15 LLDP
- 3.16 Radio Port Performance Monitoring
- 3.17 Adaptive Noise Immunity (ANI)
- 4 Mechanical Structure and Interfaces
- 5 Product Structure
- 6 Management
- 7 Technical Specification
- 8 Standards
38
DragonWave Inc.Mechanical Structure and Interfaces
The pinout definition is shown in the following table.
4.2.5 RF Interface (optional)
The RF interfaces consist of two N-type antenna connectors located on a box cover.
These interfaces are used when Lite is assembled with external antenna.
4.2.6 RSSI/EVM Interface
RSSI interface enables the measurement of the received RF signal level by means of a
standard voltmeter through a female BNC 50 ohm, an IP66 waterproof connector.
Connector type
Shielded GE RJ45 8 pin gold plated contacts.
Suggested cable Shielded twisted pair (STP cat5e), at least 24 AWG wire
Power supply The P+E power pinout is built into this port. It is an internal port
to provide power transfer between P+E and PoE+.
Pin Number Pin Function Power Pinout
1 pair A+ negative
2 pair A- negative
3 pair B+ negative
4pair C+positive
5pair C-positive
6 pair B- negative
7pair D+positive
8pair D-positive
Table 12 Pinout Definition of Internal
Property Description
Table 11 Internal