Launch Assist Wheelie Bar Directions

ManualsBrandsDragRace Concepts ManualsCars & TrucksLaunch Assist 10" Wheelie Bar w/Big Wheels (Black) (Mid Motor)

Table Of Contents

Step #3

Step #2

Step #1

Launch Assist Wheelie Bar

Install cross braces with (12) 3*6mm

button head s

crews

Install wheelie bar wheel axle into wheelie bar axle

holder using (1) 3x5mm s

ocket head screw.

Repeat for second assembly.

Install left and right wheelie bar wheel holder

assemblies using (2) 3*6mm button head

screws per side.

Summary of content (4 pages)

PAGE 1
Launch Assist Wheelie Bar Step #1 Install cross braces with (12) 3*6mm button head screws Step #2 Install wheelie bar wheel axle into wheelie bar axle holder using (1) 3x5mm socket head screw. Repeat for second assembly. Step #3 Install left and right wheelie bar wheel holder assemblies using (2) 3*6mm button head screws per side.
PAGE 2
Launch Assist Wheelie Bar Step #4 Install (2) 1/8 x 5/16 x 7/64 bearings into wheelie bar wheel. Install wheelie bar wheel onto axle and secure with e-clip. Repeat for second assembly. Step #5 Install (1) 1/8 x 5/16 x 9/64 flanged bearing into outside of the adjuster block. Repeat for second assembly. Step #6 Install (1) O-Ring,(1) Washer) into the backside of the adjuster block. Install (1) e-clip onto pin and insert through the washer and o-ring. Repeat for second assembly.
PAGE 3
Launch Assist Wheelie Bar Step #7 Install adjuster blocks onto wheelie bar arms. Step #8 Install base plate to riser using (2) 3*6mm button head screws. Step #9 Install adjuster blocks onto wheelie bar mount assembly using (2) 3*8mm socket head screws per side.
PAGE 4
Launch Assist Wheelie Bar Step #10 The wheelie bar includes ball stud style mounting hardware compatible with Custom Works MDX Long Shocks. These shock mouting directions are based on CW MDX shocks. Install ball studs / spacers onto carbon fiber in desired position using (2) 3*8mm button head screws. Install the two CW shock eyelet inserts into the shock cap. Attach top of shock to the wheelie bar mount using (2) 3*8mm button head screws. Launch Assist Wheelie Bar fully assembled on the Drag Pak Maxim.