User manual


10

Superior Broadcast
ATSC 3000 Exciter User Manual
Superior Broadcast ATSC 3000 Exciter
ATS C 3000 Exciter User Guide
Version 2.0 Page 9 of 13
10/23/2012
Note:
1) "UPGRADE" is a mode to upgrade the firmware of micro controller. It’s only available for
advanced users. If there is any misoperation, restart the exciter to cancel the upgrade process.
2) "IP", "GATEWAY", and "MASK" are used to establish a valid Ethernet connection for
remote control via RJ45. The exciter has a built-in WEB GUI which requires only a standard
web browser run by a PC. Simply by entering specified IP address, which is setup in
CONFIG sub-menu, in a browser’s address bar, the login interface will pop up and give user
prompts to input user name and password. Both the default user name and password are
"admin" (case sensitive). The "admin" account only allows users to retrieve information such
as SNR and shoulder measurements, user configuration, and alarms. Only some basic settings
such as RF switch, Power, are accessible in "admin" account. To get a full control of the
exciter, please log in with the root account, whose user name and password are "user" and
"ANWP" (case sensitive).