Instruction manual

Connecting to JVC AV Compu Link

JVC's AV CompuLink feature makes playing wdeo tapes or DVDs totally automatic. S,reply

insert a pre-recorded tape into your JVC brand VCR or DVD into your JVC DVD player and

the device Will automatically turn on and begin playback. At the same time, using the

AV CompuLink the VCR or DVD player sends a signal to the television telling it to turn or

and switch to the proper video input.

, The AV CompuLink cable may be included with the JVC AV CompuLink unit you

wish to connect. If it is not. contact JVC Parts Department at {800_-882-2345. or

www.jvcservlce.com for par[ _ EWP 805-012.

• AV CompuLink can only be used with JVC brand products.

AV CompuLink Cable

To Connect: Plug one end of the AV CompuLink cable

into the AV COMPULINK INPUT on your VCR, DVD,

or other CompuLink device. Plug the other end of the

AV CompuLink cable into the AV COMPULINK at the

rear of the television.

Note:

• The AV CompuLink cable has a male 3.5 mm (mono)

plug on each end.

TV Rear Panel

VCR

®-;®@ ,,

@=@ @ @OUT

AV CompuLink

Notes:

• In order for the VCR playback to begin automatically, the recording tabs must be removed

from the VHS tape. If the tab is in place, automatic switching will occur when you push the

VCR's PLAY button.

• If your JVC brand VCR has "A code/B code remote control switching" (see your VCR%

instruction book), using VCRA code will switch the TV to input !.

• Refer to your DVD instruction book for detailed connection information.

• To connect a JVC HiFi receiver or amplifier for a completely automated home theater, see

the receiver connection instructions for detailed connection information.

• AV CompuLink is compatible with select AV CompuLink receivers.