Instruction manual

SPECIFICATIONS
SATELLITE INPUTS
Frequency Range: 950 MHz to 2150 MHz.
Input Impedance: 75 ohm, return loss = 10 dB.
Input Level Range: - 25 dBm to - 65 dBm / transponder.
Mode: QPSK, 8PSK.
FEC: DVB-S2, DCII, advanced Turbo modes.
Symbol Rate: 2 MS/s to 30 MS/s.
6
Rev: 20130401
1002576
Notes
1. If the front panel display shows INVALID VIDEO, the incoming video is not correct for the input type and resolution
settings. If the front panel display shows INVALID AUDIO, the HDMI embedded audio source is not available or not PCM
(uncompressed).
2. This encoder will only support the specifi c video resolutions outlined in the Specifi cations table.
3. This encoder does not support HDMI copy protection (HDCP). All HDMI sources must be un-encrypted.
4. Composite video is supported - use the Component Y (greencolored) input connector.
5. Closed-captioning data is automatically extracted when the encoder is in Composite mode. All other modes require a
captioned composite video source input to the Caption connector.
6. Firmware updates may be required for MEQ1000 or EH24 chassis. MEQ1000s must be updated to v1.4 or later. EH24s
IMPORTANT NOTES
SPECIFICATIONS