USERS MANUAL GTL-3001 Operating Instructions Table of Contents 1. Unpacking and Checking Equipment 2. Operation Instructions 3. FCC Information 4.
1. Unpacking and Checking Equipment Carefully unpack the equipment and its accessories. 1). 2). 3). 4). 5). Remote controller Base communication module Main controller kinds of Harness Assembly Shock sensor 2. Operation Instructions 2-1. ARMING The car alarm system checks the intrusion into the car in the arm mode (shock & door open) and pages it the remote controller, and then, it alerts for 45 seconds with siren and light flashing. After alarm, it returns to arm mode. 2-1-1.
the system will arm automatically after 30 seconds. When the car is armed, it acts like above procedures. Note 1: Passive arming is selectable feature that can be turned ON or OFF by your alarm dealer / installer. Please check the installation guide. 2-1-3. Special functions when entering into arming : When the door is opened and the “LOCK” button is pressed, the car alerts 4 chirps & 4 light flashing.
and the remote controller turns on green LED and sounds one dual beep. And also the car alerts audible chirp with visual light flashing. Now the car is in VALET mode. Only “LOCK” “UNLOCK” & “AUX” can be activated. Even though the “LOCK” is activated, the car does not enter into ARMING during VALET mode. As the VALET mode is toggle function, the car can be return to the DISARM mode when the button “AUX” is pressed once again at the same condition.
it sends the signal to the remote controller to alert this status to the user. Now the user can recognize the triggering by the remote controller shows 15 times of green, red LED and “CRICKET” sound. The siren and light can be removed by pressing any button of remote controller. 2-13. COMMUNICATION ERROR Sometimes you can see 3 times red LED flashing and dual beeps when you press any button of the remote controller. This means that the remote controller has communication error.
3). WHITE : WHITE wire is positive output from on-board relay for light flashing. This white wire can be connected to the vehicle’s parking light wire at the headlight switch. Also this wire can be connected directly to any parking light fixture. 4). RED/WHITE ( WHITE STRIP ON RED ) : RED/WHITE wire is connected to the external relay ( or relay in the vehicle ) for trunk open. 5). GRAY : GRAY wire is connected to the dome light (-). 6).
the system will sounds 5 chirps and goes into CODE RUNNING mode. 4). Press any button of 2-way remote controller. This will finish first code running. You should use 2-way remote controller for the first code running. 5). Press any button of extra remote controller if you have or press any button of the first remote controller if you do not have extra remote controller. The second code running is finished now. And the system is in Valet mode. 6). Disable the Valet mode.
3. FCC Information Caution : Any changes or modifications in construction of this device which are not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. 4. FCC Label Information This device complies with part 15 of the FCC Rules.