User's Manual

CAR ALARM.
At this mode, the transmitter enters into ARM MODE by
ARMED-
OUTPUT being supplied from CAR ALARM.
• OPERATION OF EACH INPUT
When any input is sensed, the transmitter sends RF
signal only
once. But the transmitter does not send RF signal
when the door
or trunk is closed. The operation of each input is
mentioned
on the usage of pager. The transmitter can be used
both STAND-
ALONE and operation with CAR ALARM.
5).The receiver should do ID LEARING, after the transmitter
being
installed. When two keys are pressed simultaneously for
more then 2
seconds, the receiver enters into ID LEARING MODE with
beep tone.
At that time, the receiver shows “Id”on the LCD. If it
receives RF
signal from transmitter, the receiver decodes ID+DATA and
memorizes it
into memory in receiver. When the receiver succeeds in ID
LEARING, the
receiver sounds triple beep tone and ends ID LEARING MODE.
When the receiver does not succeed in ID LEARING for 30
seconds, it
ends the ID LEARING MODE with single long beep.