Specifications

ASSEMBLY INSTRUCTIONS

1) Check for loose parts.

2) Connect hoses to pump as shown below. Connect discharge hose first,then bypass hose,

and then intake hose. Then connect discharge hose to applicator (spray gun,spray wand,

etc.).

3) Before starting,make sure the pickup or intake hose is submerged in water. The water pro-

vides lubrication for the pump and will prevent damage to the pump.

4) Check the engine oil level. Engine should be stopped and in a level position. Remove the

oil filler cap/dipstick and wipe clean. Insert and remove the dipstick without screwing into the

filler neck. Check the oil level shown on the dipstick. If the oil level is low,fill to the edge of the

oil filler hole with the recommended oil (SAE 10W-30,or 5W-30 if below 25 degrees Fahrenheit).

To avoid over-filling or under-filling,be sure the engine is in a level position when adding oil.

5) Check the fuel level by looking through the translucent fuel tank. If the fuel level is low,

refuel in a well ventilated area with the engine stopped. If the engine has been running,allow

it to cool. To refuel,rest the engine on the ground with the fuel tank cap facing up. Remove the

fuel tank cap,and fill the tank with gasoline to the bottom of the filler neck. The recommended

fuel is unleaded gasoline with a pump octane rating of 86 or higher. Refuel carefully to avoid

spilling fuel. Do not overfill. There should be no fuel in the filler neck. After refueling,tighten the

fuel tank cap securely.

WARNING: Gasoline is highly flammable and explosive. You can be burned or serious-

ly injured when handling fuel. Stop the engine and keep heat,sparks,and flame away. Handle

fuel only outdoors. Wipe up spills immediately.

DISCHARGE HOSE

INTAKE HOSE

BYPASS HOSE