Specifications

CAUTIONS DURING OPERATION

1) When operating the pump for the first time with the pickup hose submerged in solution,set

the pressure control valve handle to the "Start" position,and allow free flow of air or water out of

spray gun or wand,to allow pump to prime with minimal resistance.

2) If the pump is operated without the pickup hose being submerged in solution it will cause

damage to the pump packing. Do not run the pump without liquid,except when draining,and

then for not more than 20 seconds.

3) When chemical is depleted,set the engine immediately to idle. This allows the clutch to dis-

engage the engine from the pump.

4) When the spraying condition is not satisfactory,increase the rpm of the engine,or remove

and clean the nozzle,and replace the orifice disk with a new disk if there are any signs of wear

or damage.

5) The equipment has a centrifugal clutch,therefore running at low rpm's will not allow the

clutch to completely expand and engage the drum. If the equipment is used with the clutch

not properly engaged,the clutch can be damaged.

6) When the engine is operated continuously at a low or medium speed for a long time car-

bon deposits will build up on top of the piston and in the exhaust port. Therefore,occasionally

run up to high speed to help remove carbon deposits. Removal of carbon should be per-

formed as regular maintenance.